I wanted to purchase a pipette stand but it seems like such a frivolous purchase. I am expected to spend $20 (eBay) to $60 (venders) to hold my pipettes vertically? Really? Ugh. As much as I wanted a pretty acrylic stand I just could not pull the trigger and buy one. This post will briefly go over how I built a pipette stand out of PVC pipe.
These instructions are for a linear pipette stand. The circular/revolving stands are an annoyance and an example of bad design. If you are suffering through one of the revolving stands I urge you to abandon it for a linear stand.
Saw or PVC cutter – Either work but the PVC cutter is easier to use and costs $10-20.
- All of the supplies needed for the stand.
Pipe is usually sold in 10 foot lengths. Most stores will cut it down smaller for free if asked. Some stores even sell shorter segments. Cut the pipe into four 8” lengths, two 6” lengths, and six 2” lengths.
Purchase four T-shaped fittings and six right-angle fittings.
T-shaped fittings (4) = $0.80
90deg fittings (6) = $1.02
½” pipe (10 feet) = $1.65
Total = $3.47
The construction of the stand is simple. All that has to be done is to cut the pipe and then assemble the structure.
As mentioned in the methods, cut the pipe into four 8” lengths, two 6” lengths, and six 2” lengths.
Next connect the fittings together with all of the 2” lengths of pipe as shown below.
Now add the 8” and 6” lengths of pipe – the stand is now complete.
(above) A view of the stand from the bottom.
(above) Fully assembled stand.
(above) A view of my home-lab with the finished pipette stand.
Latest posts by Joseph Elsbernd (see all)
- Cheapass science – Build a pipette stand from PVC pipe for $3.47+tax - March 17, 2012
- Cheapass Science – Comparison of agarose, agar-agar, and cleaned agar-agar for gel electrophoresis of DNA - January 30, 2012
- Cheapass science – DIY Vortex Mixer Tube Holder - January 19, 2012